Correctly connecting the compressed air hose is fundamental for the normal operation of a temperature shock test chamber. This type of equipment requires compressed air to function, as the gas is needed to open the valves and create temperature shocks in the test area. Therefore, it is essential to use a compressed air hose. But how can you correctly connect the compressed air hose, and are there any tips to make it easier? In fact, the key is simply to follow the correct procedure.
First, staff should connect the external air source to the inlet of the pressure regulator on the test equipment. Trim the end of the air hose to ensure a clean cut, and then insert it into the quick connector. The input air pressure required by the temperature shock test chamber (usually around 3 to 5 kg) can be adjusted through the pressure regulator (the adjusted pressure should be around 2 kg). The pressure for the spray regulator should be set to around 1 kg. When adjusting the pressure regulator, staff should first lift the knob. Turning the knob clockwise increases the air pressure, while turning it counterclockwise decreases the air pressure. After adjusting the pressure, check the pressure gauge to ensure it meets the required level. If the pressure is correct, press the adjustment knob down to complete the pressure regulation. To disconnect the air hose, close the main inlet valve first, then quickly push the plastic part of the connector inward and pull the hose out swiftly.
Now that you have read the above introduction, do you understand how to connect the compressed air hose to a temperature shock test chamber? This operation is just a part of the routine equipment handling. Typically, after purchasing the equipment, the manufacturer’s technicians will be responsible for its installation and commissioning. However, it is still important for staff to be familiar with these daily operations to facilitate future maintenance of the equipment. Our company is a producer and supplier of environmental test equipment. We provide equipment and related services to a wide range of customers. For any questions about the equipment, you can call 400-066-2888 to consult us. We will offer corresponding solutions based on your needs. Our company has also established offices in various locations to provide timely technical services to customers.
Temperature and humidity test chamber Salt spray test chamber Aging test chamber New Energy Test Chamber IP protection testing equipment Non standard customized laboratory High and Low Temperature Test Chamber Thermal Shock Test Chamber Constant Temperature and Humidity Test Chamber High and Low Temperature Low Pressure Test Chamber Salt Spray Test Chamber Rapid Temperature Change Test Chamber High and Low Temperature Alternating Humidity Test Chamber High and Low Temperature Humidity Test Chamber Low Temperature Test Chamber High Temperature Test Chamber High and Low Temperature Alternating Test Chamber Damp heat test chamber for antirust oil and grease UV Aging Test Chamber Ozone Aging Test Chamber Air-exchange Aging Test Chamber Rain Test Chamber Sand and Dust Test Chamber Sulfur Dioxide Test Chamber Mold Test Chamber Ultra-Low Temperature Test Chamber Salt Spray Corrosion Test Chamber Condensation Test Chamber HAST Test Chamber Thermal Vacuum Test Chamber Battery Explosion-proof Test Chamber battery test chamber Photovoltaic PV module UV test chamber Sunlight simulation test chamber Photovoltaic wet freezing test chamber Photovoltaic Dustproof Test Chamber
EN
中文
Pусский
Ti?ng Vi?t
???????
???????? ????
