Analysis of Fault Alarm Principles in Constant Temperature and Humidity Chambers
Over-temperature Alarm in the Chamber: The sample area sensor and the channel are equipped with over-temperature protection devices. An over-temperature protection device is also installed on the control panel. If the temperature in the test area exceeds the allowable temperature set on the panel, the equipment will shut down and trigger an alarm. The TH setting must be at least 10°C higher than the operating temperature for the equipment to function.
Sample Over-temperature Protection: If the temperature in the sample area exceeds the protection temperature set by the controller, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and the system is reset. Sample over-temperature protection includes both upper and lower limits, which can be arbitrarily set by the user as needed.
Fan Overheating Alarm: If the fan coil overheats, the equipment will shut down and alarm. Operation can only resume after the fault is resolved.
Fan Overcurrent Alarm: If the fan current exceeds the allowable value, the equipment will shut down and alarm. Normal operation can only resume after the overcurrent fault is repaired.
Cooling Water Shortage Alarm: If the water pressure in the cooling circulation system is insufficient, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and the system is reset.
Refrigeration Compressor Overheating Alarm: If the compressor coil overheats or the circuit power supply is abnormal, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved.
Refrigeration Compressor Overpressure Alarm: If the refrigerant pressure in the refrigeration system exceeds the set value, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and manually reset.
Power Phase Loss or Phase Sequence Alarm: If the external power supply experiences phase loss or phase sequence reversal, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved.
Temperature and humidity test chamber Salt spray test chamber Aging test chamber New Energy Test Chamber IP protection testing equipment Non standard customized laboratory High and Low Temperature Test Chamber Thermal Shock Test Chamber Constant Temperature and Humidity Test Chamber High and Low Temperature Low Pressure Test Chamber Salt Spray Test Chamber Rapid Temperature Change Test Chamber High and Low Temperature Alternating Humidity Test Chamber High and Low Temperature Humidity Test Chamber Low Temperature Test Chamber High Temperature Test Chamber High and Low Temperature Alternating Test Chamber Damp heat test chamber for antirust oil and grease UV Aging Test Chamber Ozone Aging Test Chamber Air-exchange Aging Test Chamber Rain Test Chamber Sand and Dust Test Chamber Sulfur Dioxide Test Chamber Mold Test Chamber Ultra-Low Temperature Test Chamber Salt Spray Corrosion Test Chamber Condensation Test Chamber HAST Test Chamber Thermal Vacuum Test Chamber Battery Explosion-proof Test Chamber battery test chamber Photovoltaic PV module UV test chamber Sunlight simulation test chamber Photovoltaic wet freezing test chamber Photovoltaic Dustproof Test Chamber
EN
中文
Pусский
Ti?ng Vi?t
???????
???????? ????
